[. . . ] This charger is designed for indoor use : do not expose to damp or rain. ⷠUse the charger only for Nickel-Cadmium (Ni-Cd) or Nickel-Metal Hydride (Ni-MH) batteries. [. . . ] It will be returned to an approved centre which will reuse and recycle its constituent parts, whilst neutralising any possible substances harmful to health or the environment. By participating in separate waste collection, you are contributing to reducing wastefulness of our natural resources. Classic universal charger The UNIROSS universal charger is designed to charge Ni-Cd or Ni-MH batteries in the following sizes/quantities: - 1 to 4 batteries size AAA / R03 / Micro - 1 to 4 batteries size AA / R6 / Mignon - 1 to 4 batteries size C / R14 / Baby - 1 to 4 batteries size D / R20 / Mono - 1 to 2 batteries size 9V Block / R22 / PP3. You can charge several battery sizes at the same time: take care to observe times for different size batteries (see table below). Description 1 Minutery selector : position A = 4h / position B = 8h 2 Locations A, B, C and D to charge batteries sizes AAA / R03 / Micro, AA / R6 / Mignon, C / R14 / Baby and D / R20 / Mono 3 Red indicator lights (respectively CH1 to CH4) indicates that charging of battery sizeq AAA, AA, C and D are underway. 4 Locations E and F to charge batteries of the 9V Block / R22 / PP3 size. 5 Green indicator light denoting that the charging of 9 V Block / R22 / PP3 size batteries in locations E and/or F is in progress. This timer trips automatically when the charger is plugged into the power point. therefore , it is important: · To disconnect and reconnect the charger each time new empty batteries are to be charged. ⷠDuring the charge, not to disconnect and reconnect the charger unless the batteries have been discharged in the meantime. [. . . ] When charging PP3 size batteries the charging channel LED will glow GREEN to indicate charging is taking place; remove from charger after time (see table of charge time), automatic timer control is not applicable for `PP3' size battery. ⷠIf charging lights fail to illuminate it is possible that charging contacts or battery terminals are dirty, wipe with clean dry cloth and try again. [. . . ]